ASME_GT2012-69385.pdf (944.14 kB)
Windage measurements in a rotor stator cavity with rotor mounted protrusions and bolts
journal contribution
posted on 2023-06-08, 14:00 authored by Christopher Long, Anna Louise Miles, Daniel CorenThis paper reports an experimental investigation of the windage associated with enclosed rotor-stator systems with superposed throughflow, as commonly found in gas turbine engines. The term windage is often used to describe the viscous heating that arises from the interaction of surfaces and fluids in rotating disc systems. Since the presence of circumferentially discreet geometric features strongly alters the magnitude of Windage measured, the physical mechanisms collectively referred to as windage in this paper are separately described as part of the discussion of results. Tests have been carried out to measure windage directly in the form of shaft torque and also rotor surface temperature. Non-dimensional flow parameters are used to expand the relevance of the data obtained, which encompasses the ranges 0.17 x 107 = Ref = 1.68 x 107and 0.24 x 105 = Cw = 1.06 x 105 which corresponds to 0.058 = ?T = 0.631. Data has been obtained for smooth disc geometry and also with rotor mounted protrusions of N = 3, 9 and 18; D = 10 mm, 13 mm and 16 mm diameter; H = 11 mm, high, hexagonal bolt shaped protrusions. Bi-hexagonal (twelve sided) bolts of D = 13 mm effective diameter, and height, H = 11mm, were also tested with conditions closely matched to the 13 mm hexagonal bolts. Finally, tests with 10 mm diameter, 6 mm deep, pockets were also carried out. Over the range of conditions and geometries tested, increasing the number of bolts increases the moment coefficient and windage heating. At low values of turbulent flow parameter, ?T, which correspond to rotational speeds between 8000 and 10000 rev/min, increasing the diameter of the bolts shows a clear trend for both increased windage torque and average disc temperature rise. For these conditions, there also appears to be a clear reduction in windage and temperature rise with the bi-hexagonal shaped bolts compared to the equivalent diameter hexagonal bolt form. Variation in the moment coefficient with the number and diameter of bolts is attributed to variations in form drag between the different configurations. The introduction of the recesses onto the disc has very little effect on either windage heating or moment coefficient; this is attributed to the component of windage mechanism in operation and also the relatively small size in comparison to the protrusions studied here. This work contributes to the understanding of windage in gas turbines by introducing new low uncertainty data obtained at engine representative conditions and as such is of benefit to those involved with the design of internal air systems and disc fixtures
History
Publication status
- Published
File Version
- Published version
Journal
Proceedings of ASME Turbo Expo 2012Publisher
American Society of Mechanical EngineersDepartment affiliated with
- Engineering and Design Publications
Notes
June 11-15, 2012, Bella Center, Copenhagen, Denmark GT2012-69385 Ebook; no ISBN; no page refsFull text available
- Yes
Peer reviewed?
- Yes
Legacy Posted Date
2012-11-30First Open Access (FOA) Date
2013-07-29First Compliant Deposit (FCD) Date
2012-11-30Usage metrics
Categories
No categories selectedKeywords
Licence
Exports
RefWorks
BibTeX
Ref. manager
Endnote
DataCite
NLM
DC